Flat and Low-Slope Roofing in St. Petersburg, FL

Modified bitumen, TPO and coatings for homes, Florida rooms, carports, additions and commercial buildings.

Flat and low-slope roofs are everywhere in St. Petersburg: mid-century block homes, Florida rooms, carports, additions and most commercial buildings. They fail differently than shingle roofs. Water ponds, seams open, and drains clog. Mitchell Roofing repairs and replaces flat roofs in modified bitumen and TPO, and installs coatings where the roof is sound but aging.

Why flat roofs leak in Florida

  • Ponding water. Any spot that holds water 48 hours after rain is a leak waiting to happen.
  • Open seams. Heat cycles pull seams apart, especially on older torch-down and rolled roofing.
  • Clogged drains and scuppers. Oak leaves and pine needles stop the roof from draining.
  • Flashing at walls and curbs. The transition where the flat roof meets a wall or an AC unit is where most leaks start.
  • Punctures. Foot traffic, dropped tools and AC service.

Modified bitumen or TPO?

  • Modified bitumen. Asphalt-based rolled membrane, torch-applied or self-adhered, usually two layers with a granulated cap sheet. The standard for residential flat roofs and smaller commercial buildings in Tampa Bay. 15 to 20 years. More in the rise of modified bitumen.
  • TPO. A white single-ply membrane with heat-welded seams. Reflective, which cuts cooling costs, and the usual choice for larger commercial roofs. 20 to 25 years when installed with the right thickness and fastening.
  • Coatings. A silicone or acrylic coating over a sound existing roof adds years and reflectivity at a fraction of replacement cost. Not a fix for a wet or failing roof. Spray foam is another option on commercial roofs: see 10 benefits of spray polyurethane foam roof systems.

Flat roof repair

Seams rewelded or re-torched, blisters cut and patched, flashing rebuilt, drains cleared and scuppers added where water ponds. A repair comes with a moisture check, because a wet insulation layer under a patched membrane will fail again. For an active leak, see emergency roof repairs.

Flat roof replacement

Tear-off to the deck, deck repair, tapered insulation to move water to drains where ponding has been a problem, new membrane, new edge metal and flashing, permit and inspection. Mitchell handles the flat section and the shingle or tile section of a mixed roof in one job, so the tie-in is done right.

Associations with flat roofs on mid-rise buildings, see condo and HOA roofing.

Frequently asked questions

How long does a flat roof last in Florida?

Modified bitumen 15 to 20 years, TPO 20 to 25, with annual drain cleaning and prompt seam repairs.

Can you put a coating over my flat roof instead of replacing it?

If the roof is dry and the seams are sound, yes. If the insulation is wet, no. We check with a moisture meter first.

Is a flat roof leak an insurance matter?

That is between you and your insurer under your policy. What we can tell you is the cause, since ponding and seam failure are wear, and we document what we find with photos and an itemized estimate you can share.

Can you add slope to a flat roof?

Tapered insulation during replacement moves water to the drains without changing the structure.

Do you do flat roofs on commercial buildings?

Yes. See the commercial roofing page.

Get your roof handled before the next storm finds the weak spot.

Roof repair, replacement, inspections and storm damage across Pinellas and the Florida Gulf Coast.

Call Now